Assembly; Preparation; Required Tools; Assembling The Grill - tepro Fremont Aufbau- Und Bedienungsanleitung

– Exercise extreme caution when grilling. If you are distracted, you
could lose control of the device.
– Be attentive at all times and be aware of what you are doing. Do
not use the device if you lack the necessary concentration or are
fatigued or under the influence of drugs, alcohol or medication.
A single moment of inattentiveness when using the device may
result in serious injury.
Attention Risk of damage!
The screwed connections may gradually loosen during
use and affect the stability of the grill.
– Before you use the unit, always check to make sure the screws
are secure.
– If applicable, tighten all screws again to ensure that the grill is
stable.
Attention Risk of damage!
Improper handling of the grill may result in damages.
– Do not use any strong or abrasive solvents or scouring pads as
they may attack and scratch the surfaces.
– Protect the gas regulators from being contaminated by oil or
mud etc.
– Once you have connected the gas hose to the container valve,
do not turn the pressure regulator any further (risk of a gas leak
around the gasket).
– If the pressure regulator is used normally, it must be replaced
with a new one no later than 10 years after the date of manufac-
ture. Only in this way, can proper functioning be ensured.
10
92221 LB sonder innen 20121123.indb 10 92221 LB sonder innen 20121123.indb 10
GB CY

Assembly

Preparation

Danger Risk of injury!
Failure to observe the instructions may result in prob-
lems and risks when using the grill.
– If applicable, wear safety gloves to protect against sharp edges.
– Always follow all assembly instructions provided.
1. First completely read through the assembly instructions.
2. If necessary, have another person assist you.
3. Take enough time for the assembly and clear a work area of two
to three square meters.
4. Arrange the required tools so that they are within reach. Small
parts such as handles may be premounted.

Required tools

– Cross-slotted screwdriver
– Pliers or
• 10 mm wrench / socket key for M6 nuts
• 8 mm wrench / socket key for M5 nuts
• 7 mm wrench / socket key for M4 nuts
– 1 x 17-size open-end wrench
(national specifications may require the use of another corre-
sponding open-end wrench)

Assembling the grill

Assemble the grill as shown in figures A - Z.
Please observe the following assembly notes:
– Regarding fig. A and B: Please observe the stickers and Velcro
strips on the legs. The Velcro strips must be facing inward.
– Regarding fig. D: Please observe the stickers and make sure that
the threaded holes are facing inward.
Insert the rear screws so that the screw head is on the inside. Oth-
erwise the side table (9) could bump up against the protruding
screw when folded down.
– Regarding fig. G: Tighten the screws so that the burner housing
(7) is flush with the support (25/8).
– Regarding fig. H: Insert the burner (5) so that the nozzles of the
temperature controls extend into the burner connecting tubes.
The tube ends rest loosely above the nozzles. This gap is de-
sired!
– Regarding fig. O: Depending on national specifications, there
are various possibilities for connecting the gas hose (20) to the
grill (fig. O only shows one example for connecting the pressure
regulator). First take the protective cap off of the gas connection
(19), if present, and dispose of it.
Method 1: Screw one end of the gas hose (20) onto the gas connec-
tion until tight (left-hand thread). Do not use an extra gasket! Hold
the gas connection firmly with pliers or an open-end wrench and
then use an open-end wrench to tighten the union nut of the gas
hose.
Method 2: Slide a hose clamp of the right size a few centimetres over
the loose end of the gas hose (20).
Then slide this end onto the gas connection (19) (wet the gas con-
nection somewhat to facilitate sliding onto the hose). Fix the con-
nection with the hose clamp.
Connect the other end of the gas hose (20) with the included pres-
su
Se
an
clo
an
sp
La
–
S
A
–
5.
6.
7.
8.
9.
10
C
Yo
or
No
lif
–
–
–
11
12
26.11.12 15:59 26.11.12 15:59