Preparing The Telephone - switel TF 510 Bedienungsanleitung

2 Preparing the Telephone

Connecting the telephone
Connect the helix cable at positions 12
(refer to following page). Only use the
helix cable supplied because the
equipment may not function if another
helix cable is used.
Connect the phone (19) to the tele-
phone connection socket using the te-
lephone connection line. Only use the
telephone connection line supplied be-
cause the equipment may not function
if another telephone connection line is
used.
Wall mounting
The telephone can also be installed on a wall. You require two
screws in order to fix the telephone on a wall. Drill two holes at a
distance corresponding to the slots (100 mm apart) and insert the
screws leaving approx. 5 mm projecting from the wall. Align the
slots in the telephone to the screws, fit the screws in the slots and
slide the telephone downwards a little.
Inserting batteries
Insert the batteries in the open battery compartment (20). Only
use batteries of the type AA Alkaline 1.5 V. Pay attention to correct
polarity. Close the battery compartment cover.
34
The display is only active when batteries have been in-
serted. If the BATT. LOW message appears in the dis-
play, change the batteries.
Telephone connection
19
+ AA −
+ AA −
+ AA −
+ AA −
+ AA −
+ AA −
Helix cable
12
12