Eibenstock END 1550 P Originalbetriebsanleitung Seite 26

Fixing the drilling machine at the drill rig:
For fixing the machine at the drill rig remove both Allen screws M8 (Fig. 2
C) and take off the collar clamp. Remove the additional handle of the
diamond drilling machine. The water supply has to remain at the machine
and can be fixed on the gripper clamp at the drill rig. Put the machine on the
carriage and close the collar clamp with the Allen screws.
Fixing of the drill rig:
First open the two levers (Fig. 2 D) on the suction feeds. Position the drill rig
on the desired place.
The surface has to be absolutely smooth and polished.
Close the levers and check the firmly seat of the drill rig.
By means of the both adjusting levers for slewing of the column (Fig. 2 E)
and for adjusting of the height of the support (Fig. 2 F) you can adjust the
optimal drilling position.
The support increases the stability of the drilling unit on drilling and has to
be adjust, that it has a firmly seat on the working surface.
For further information please see the operating instructions of the
drill rig.
Care and Maintenance
Before the beginning of the maintenance or repair works
you have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist.
Due to its design, the machine needs a minimum of care and maintenance.
The following works have to be carried out regularly or rather the
component parts have to be inspected:
The power tool as well as the ventilation slots always have to be
clean.
During work, please pay attention that no foreign elements get into
the interior of the machine.
In case of breakdown, a repair has to be carried out by an authorised
service workshop.
26