Eibenstock END 1550 P Originalbetriebsanleitung Seite 19

Application for Intended Purpose
The Diamond wet drill END 1550 P is intended for professional use and
may be used only by instructed personnel.
It may be used either with or without an adequate drill rig.
With the appropriate diamond drill bits the tool may be used for wet drilling
of holes up to 68 mm diameter maximum in tiles, stoneware and natural
stone (up to a maximum drilling depth of 40 mm) as well as up to 30 mm
diameter maximum in concrete, reinforced concrete and brickwork.
Safety Instructions
Safe work with the machine is only possible if you read
this operating instructions completely and strictly follow
the instructions contained herein.
In addition, the general safety instructions in the
enclosed brochure have to be observed. Take part in a
practical introduction before the first use.
If the connecting cable is getting damaged or cut during
the work, don't touch it, but instantly pull the plug out of
the socket. Never use the machine with damaged
connecting cable.
When drilling in ceilings or walls make sure you will not
cut through electrical mains, gas or water pipes. Use
metal detection systems if needed.
Before you start working, consult a statics specialist to
determine the exact drilling position. If drilling through
ceilings, secure the place below, because
the core may drop out.
Pay attention that the tool is not exposed to direct rain.
Do not use the tool in an environment with danger of explosion.
Do not use the tool standing on a ladder.
Do not drill into materials containing asbestos.
Never carry the tool at its cable and always check the tool, cable and
plug before use. Have damages only repaired by specialists. Only
insert the plug into the socket when the tool switch is OFF.
Modifications of the tool are prohibited.
The machine should only run under supervision of somebody. Plug
and switch the machine off if it is not under supervision, e.g. in case
of setting up and stripping down the machine, in case of voltage drop
or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
19