circuit is not completed, it may cause fire or electric shock.
The device must be grounded. If power supply does not have grounding device, be sure not
6
to connect the device.
The device should be only removed and repaired by professional technician. Improper
7
movement or maintenance of the device may cause water leakage, electric shock, or fire.
Please find a professional technician to do.
Don't unplug or plug power during operation. It may cause fire or electric shock.
8
Don't touch or operate the device when your hands are wet. It may cause fire or electric
9
shock.
Don't place heaters or other electrical appliances near the power wire. It may cause fire or
10
electric shock.
The water must not be poured directly from the device. Do not let water to permeate into the
11
electrical components.
WARNING
Do not install the device in a location where there may be flammable gas.
1
If there is flammable gas around the device, it will cause explosion.
2
According to the instruction to carry out drainage system and pipeline work. If drainage system or
pipeline is defective, water leakage will occur. And it should be disposed immediately to prevent
other household products from getting wet and damage.
Do not clean the device while power is on. Turn off power before cleaning the device. If not
3
it may result in injury from a high-speed fan or electric shock.
Stop operating the device once there is a problem or an fault code. Please turn off power
4
and stop running the device. Otherwise it may cause electric shock or fire.
Be careful when the device is not packed or not installed. Pay attention to sharp edges and
5
fins of heat exchanger.
After installation or repair, please confirm refrigerant is not leaking. If refrigerant is not
6
enough, the device will not work properly.
The installation of external device must be flat and firm. Avoid abnormal vibration and noise.
7
Don't put your fingers into fan and evaporator. High speed running fan will result in serious
8
injury.
12