Selecting The Modes Of Operation; Changing The Tool - Kress 550 HMSL Original Bedienungsanleitung

Operation
Selecting the direction of rotation
Operate the rotational direction switch VII only
when the machine is at a standstill!
Set the required direction of rotation.
Clockwise rotation:
For drilling and fixing screws.
Anticlockwise rotation:
For loosening and removing screws
and nuts.
Important: Press the rotational direction switch VII
up to the stop on the housing, i. e. until it snaps in
audibly.
If the rotational direction switch VII is set between
the positions "R" and "L", the machine cannot be
switched on.

Selecting the modes of operation

The operational mode switch II can be used to se-
lect the required settings.
The switchover can be performed best at standstill.
After the On/Off switch V has been actuated and
the machine has started, the gearbox switches to
the preselected setting.
Impact drilling
Impact drilling
-NOTE-
Left rotation when impact drilling damages the drill.
Switch off the impact mechanism for diamond
crown drilling or for mixing work.
When hammer drilling, only use drills with tungsten
carbide inserts and SDS-Plus shafts.
The use of commercially available rock drills with
cylindrical shafts by means of the adapter 6 and a
normal drill chuck in conjunction with the pneumat-
ic impact mechanism is not possible.
Drilling / Stirring
Drilling / Stirring
Adjusting the chisel
Positioning the chisel
The chisel can now be turned by hand to the re-
quired working position.
The chisel latches automatically as soon as it is ra-
dially loaded by the working or chiselling process.
-NOTE-
In devices where the selection of the above symbol
is not available, put the operational mode switch in
an intermediate position.
Chiselling
Chiselling
-NOTE-
In some devices, the gear selector/rotation stop
switch III must be used at this point. Please take
note of the enclosed illustrations.

Changing the tool

Disconnect the plug from the power
source before making any adjust-
ments, changing accessories, or stor-
ing power tools.
Such preventive safety measures
prevent accidental start of the power
tool.
Wear safety gloves for tool chang-
ing.
The tool insert can become very hot
after working for long periods and/or
the cutting edges of the tool insert are
sharp.
English 19
EN
BH-EN / 1011