Noise Information; Vibration Information; Operation - Kress KUX21 Originalbetriebsanleitung

ACCESSORIES
Auxiliary handle
Depth gauge
Grease
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose the
type according to the work you intend to undertake.
Refer to the accessory packaging for further details.
Store personnel can assist you and offer advice.

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K
PA WA
Wear ear protection.
VIBRATION
INFORMATION
Vibration total values (triax vector sum) determined
8
according to EN 60745:
EN
Hammer drilling
into concrete
Chiselling
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
L :94.3dB(A)
pA
L :105.3dB(A)
wA
Vibration emission value a
8,152m/s
2
Uncertainty K= 1.5m/s²
Vibration emission value a
14,6766m/s
2
Uncertainty K= 1.5m/s²
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
1
job. This may significantly reduce the exposure level
over the total working period.
1
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
1
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
3.0dB(A) instruction book carefully.
INTENDED USE
The machine is intended for hammer drilling in
concrete, brick and stone as well as for light chiseling
work.
WARNING! Before any work on the
machine itself, pull the mains plug.

OPERATION

=
Selecting The Operating Mode
h,HD
Inserting Drill Bits
Removing Drill Bits
=
Adjusting the Auxiliary Handle
h,CH
Using the Depth Gauge
On/Off Switch
Lubrication Machine
Caution: Keep the container
of grease away from children.
Replacing the Brushes
Unscrew the carbon brush cap
●
with screwdriver.
When brushes need replacement
●
always renew both brushes.
Completely screw down the
●
carbon brush cap. Check that the
tool is working. Before use, allow
it run for a few minutes to enable
the brushes to settle.
CONSTANT ELECTRONIC
CONTROL
OVERLOAD PROTECTION
Action
See Fig. A
See Fig. B1
See Fig. B2
See Fig. C
See Fig. D
See Fig. E
See Fig. F
See Fig. G1,
G2
/
/
Figure