Putting Into Operation; Additional Handle - Kress 550 HMSL Original Bedienungsanleitung

Operation
This may significantly reduce the exposure level
over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and accessories, keep the hands
warm, organisation of work patterns.
1st n = Idle speed (1st gear)
0
2nd n =Idle speed (2nd gear)
0
1st n = Load speed (1st gear)
1
2nd n =Load speed (2nd gear)
1
in rpm
Impact energy per stroke according to
EPTA-Procedure 05/2009
Number of impacts n
EPTA 05/2009
Corner dimension in mm
Collar diameter in mm
Weight in kg
Your device is fitted with an SDS-plus
automatic locking device.
Your device has a manual SDS-plus
locking device.
Drilling and hammer drilling in con-
crete - max. ø in mm
Drilling and hammer drilling in brick -
max. ø in mm
Drilling and hammer drilling in sand-
stone - max. ø in mm
Drilling in steel - max. ø in mm
Drilling in aluminium - max. ø in mm
Fitting screws in wood - max. ø in
mm
Drilling in wood - max. ø in mm
The machine is radio and TV interference-free in
accordance with EN 55014-1 and interference-
proof in accordance with EN 55014-2.
4. Operation

Putting into operation

-1
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.

Additional handle

Place the additional handle 3 in the working posi-
tion to provide a safe and fatigue-free working sit-
uation.
Tighten the lower hand grip of the additional han-
dle 3 by turning in a clockwise direction. Turn the
hand grip in an anticlockwise direction to release it.
Depth setting
The required drilling depth X can be set using the
depth stop 4.
Release the additional handle 3 and insert the
depth stop 4 into the additional handle.
Extend the depth stop 4 until the distance between
the tip of the drill and the tip of the depth stop 3 cor-
responds to the required drilling depth X.
Your power tool is doubly insulated in
compliance with EN 60745; there is
thus no need for an earth wire.
Before carrying out any work on the
machine, pull the mains plug.
Observe correct main voltage!
Fit the additional handle
Connect mains cable module if necessary
If using an extension cable: Only use
extension
approved for the application with the
required cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged cables.
Operate the machine only with the ad-
ditional handle
Loss of control can cause personal in-
jury.
English 17
cables specifically
BH-EN / 1011
EN