What To Do If - Becker Centronic VarioControl VC360-II Montage & Betriebsanleitung

Solar panel
Rated voltage
Degree of protection
Permissible ambient temperature
Dimensions (LxWxH)
Type of mounting
Problem
Tubular drive is not functioning.
The tubular drive travels in the open-
ing/closing direction in dead-man
mode.
Battery cannot be charged.
The indicator lamp LED gives a short
red flash every 10 seconds.
36 - en

What to do if...?

Program new transmitter.
Bring transmitter within range of the
VC360.
Press drive or stop button on trans-
mitter at least 5 times in the immedi-
ate vicinity of the VC360.
Check electrical connection.
Charge battery.
Briefly press the programming but-
ton on the VC360 to put the control
unit in the operating mode.
Charge battery.
Check connection with solar panel.
Replace solar panel with a new one.
Replace battery with a new one.
The battery is low and must be
charged.
15 V DC
IP X4
-25 °C to +55°C
405 mm x 60 mm x 6 mm
Surface mounted
Remedy