What To Do If; Simplified Eu Declaration Of Conformity - Becker Centronic VarioControl VC470-II Montage & Betriebsanleitung

Problem
Drive is not functioning.
Drive is running in the wrong direc-
tion.
The radio receiver does not perform
manual run commands.
The radio receiver does not perform
automatic run commands.
Intermediate position I / II cannot be
programmed.
Venetian blind tilts in the lower limit
position with a delay.
The shading solution retracts without
a manual or automatic drive com-
mand.

Simplified EU declaration of conformity

Becker-Antriebe GmbH hereby declares that this radio control system com-
plies with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following
web address:
www.becker-antriebe.com/ce
Subject to technical changes without notice.
32 - en

What to do if...?

Check connection.
Use the direction switch to correct
the running direction.
Program transmitter.
Program transmitter.
Set the transmitter's slide switch to
Automatic mode.
Delete intermediate position I / II and
reprogram.
Delete intermediate position II.
Set intermediate position I.
Check the radio communication
between the sensor and receiver.
You can extend the shading solution
for one hour in dead-man mode.
Remedy