Working Instructions; Adjustments On The Radial Tile Cutter; Maintenance And Care; Maintenance And Cleaning - ATIKA ST 200 Originalbetriebsanleitung

Working instructions

Before commencing work, ensure the
following:
Workplace tidied?
Is the radial tile cutter stably mounted?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Working with the radial tile cutter
Keep your hands always in a safe distance to the
rotating cutting-off wheel.
Do not start working before the cutting-off wheel has
reached its maximum rotational frequency.
Pay attention to that the cooling water pump (26) washes
water to the cutting-off wheel.
Only workpieces which have been securely mounted and
aligned can be processed.
Ensure that you always comply with the safety
instructions given on p. 13 ff.

Adjustments on the radial tile cutter

Replacing cutting-off wheel
Before replacing the cutting-off wheel pull
out the power plug.
Do not use any damaged cutting-off wheels or such which
have changed their shape.
Only use sharp cutting-off wheels.
Replacing cutting off wheel
1. Loosen the screws (29) and remove the covering cap
E
(28).
2. Put the ring spanner wrench (36) on the flange and the
installation wrench (35) on the motor shaft end and loosen
the flange (32).
Left-handed thread!
3. Remove the flange.
4. Now you can remove the cutting-off wheel (33).
5. Check the spindle, spindle nut and flanges for damages,
wearing or loose fit before mounting the cutting disk.
Immediately replace damaged or worn parts.
6. The installation of the cutting-off wheel is carried out in
reverse order.
Observe the rotational direction!
7. Fasten the flange tightly.
Left-handed thread!
8. Screw on the covering cap (28).
E F
-
F
Carrying out angle cuts
When performing the adjustment works pay attention to
that the machine is switched off and pull the saw head
backwards.
Adjusting from 0° – 90 °
1. Loosen the star handled nut (14) and turn the angle
stopper (13) until the desired angle is indicated on the
scale (0°- 90°).
2. Refasten the star handled nut in order to fix the adjusted
angle.
3. Put the tile on the stop rail (11) and the angle stopper (13).
4. Start the machine and wait until the cooling water is
flushed to the cutting-off wheel.
5. Pull the cutting unit (18) by moving the handhold (23)
slowly and constantly through the tile.
6. Switch off the machine after finishing the cut.
Setting of mitre cut (jolly cut)
1. Loosen the set screws (24) on both sides of the machine
and pull then the cutting unit (18) by moving the handhold
(23) to the desired position until the desired angle is
G
indicated.
2. Refasten the set screws (24).
3. Carry out the cut as described in point „Adjusting from 0°-
90°".

Maintenance and cleaning

Before each maintenance and cleaning work
− switch off device
− wait for standstill of the radial tile cutter
− pull out main plug
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Observe the following in order to keep the operability of
the radial tile cutter :
Clean and oil all moving parts regularly.
Remove dust and dirt with a cloth or a brush.
Do not clean the machine with running water or high-
pressure cleaners.
Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
Clean the collecting trough and the cooling water pump after
each application in order to guarantee the cooling of the
cutting-off wheel.
Never use any grease!
Use for instance environmentally acceptable spray oil.
17
H
H
G