Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Contents
EC Declaration of Conformity
according to EC directive: 2006/42/EC
We,
ATIKA GmbH & Co. KG
Schinkelstraße 97
59227 Ahlen - Germany
herewith declare under our sole responsibility that the product
Radialfliesenschneider (Radial tile cutter) ST 200
Serial number: see last page
is conform with the above mentioned EC directives as well as with
the provisions of the guidelines below:
2004/108/EC and 2006/95/EC.
Following harmonized standards have been applied:
EN 12418:2000+A1; EN 60825-1:2007; EN 55014-1:2006;
EN 55014-2/A1:2001; EN 61000-3-2:2006; EN 61000-3-3/A2:2005
Keeping of technical documents at:
ATIKA GmbH & Co. KG - Technical department
Schinkelstr. 97 - 59227 Ahlen - Germany
Ahlen, 25.05.2010
Extent of delivery
• Radial tile cutter ST200
• Base frame
• Trough
• Angle stopper
After unpacking, check the contents of the box
That it is complete
A. Pollmeier, management
• Tools for assembly
works
• Screw bag
• Operating manual
Check for possible transport damage
Report any damage or missing items to your dealer, supplier or
3-4
the manufacturer immediately. Complaints made at a later date
13
will not be acknowledged.
13
13
Symbols machine
13
14
Carefully read operator's manual before handling
14
the machine. Observe instructions and safety rules
14
when operating.
14
14
Danger - objects may be thrown out at high speed
16
when motor is running. Keep people, pets and
16
domestic animals out of the danger area.
17
17
17
Shut off engine and remove power cord before
18
performing cleaning, maintenance or repair work.
18
18
18
19
Attention! Risk of cutting! Do not hold hands into
19
the rotating disc!
Always use a diamond-tipped cutting disk with
continuous rim.
Do not expose to rain. Protect against humidity.
Wear dust protection.
Wear eye and ear protection.
Wear protection gloves.
Symbols Operating instructions
Threatened hazard or hazardous situation. Not
observing this instruction can lead to injuries or cause
damage to property.
Important information on proper handling. Not
observing this instruction can lead to faults in the
machine.
User information. This information helps you to use all
the functions optimally.
Assembly, operation and servicing. Here you are
explained exactly what to do.
Operating times
Before initiating the device please observe the provisions
pertaining to corresponding laws (regional provisions) for the
noise control.
13
Werbung
Kapitel
Inhaltsverzeichnis
