Transport; Storage; Guarantee; Possible Faults - ATIKA ST 200 Originalbetriebsanleitung

Transport

Remove the mains plug before each
transport.
Transport the radial tile cutter only when the cutting unit
is fixed:
Loosen the star handled nuts of the stopper (17).
Push transportation locks to the cutting device (18).
Refasten the star handled nuts.
That's how you avoid injuries on the hands.
Drain the cooling solution completely before any
transport.

Possible faults

Before each maintenance and cleaning work
− switch off device
− wait for complete standstill of the radial tile cutter
− pull out main plug
After repair and before re-operation control and reactivate all security installations.
Fault
Radial tile cutter does not work.
Radial tile cutter cuts with
interruptions
Cutting-off wheel gets hot
Motor hums, cutting-off wheel
stops
Possible cause
no power
extension cable damaged
main plug, motor or switch defect
extension cable damaged
internal loose connection
on-off switch defect
Cutting-off wheel is edgeless or defect
Missing cooling
Cutting-off wheel blocks

Storage

Remove the mains plug
from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
Before a longer storage observe the following in order to
prolongate the service life of the machine and to guarantee a
smooth running operation:
− thoroughly clean the machine
− treat all movable parts with an environmentally friendly
oil
Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.
Removal
Check power supply, power socket and
fuse
protection
Check extension cable, exchange defect
cable immediately
Have motor or switch checked by an
approved electrician or replaced by original
spare parts.
Check extension cable, exchange defect
cable immediately
Please contact the after sales service.
Replace cutting-off wheel
Check cooling water pump and hose
Refill water
Remove object
18