Preparing For Commissioning; Switching Off; Before The First Commissioning; Working Instructions - ATIKA ST 250 Bedienungsanleitung

Preparing for commissioning

To achieve perfect function of the machine, follow the
notes given in these instructions
You have to attach the following parts:
Base frame
Cooling water pump
Assembly of the base frame and the cooling water
pump -
B D
1. Assemble the main pillars (1) with the screws (4) and the
spring washers (5) on the frame.
2. Screw the clamp holders (6) with the star handle nuts (7)
and the coach bolts (8) on the frame (3).
3. Put the trough (9) into the frame (3).
4. Put the cooling water pump (26) into the intended gap of the
D
trough.
5. Fill water into the trough until the cooling water pump is
covered with water.
6. Put the radial tile cutter into the trough.
Commissioning
Mains connection
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the saw to the
relevant and properly earthed plug
Alternating current motor:
Use a shockproof plug, mains voltage 230 V with residual
current circuit breaker and 10 A inert fuses.
Use connection cable or extension cable respectively with
a cross section of at least 1,5 mm².
Daily checks of the PRCD (residual-current-operated
circuit breaker)
The device must be connected via the residual-current-
operated circuit breaker (PRCD).
„Reset"
„Test"
1. Directly plug the PRCD into the outlet (vertical).
2. Press the green Reset key – you will hear a click and the
indicator will light up orange.
3. To check the PRCD press the blue test key. The indicator
panel should no longer light.
B
C
Perform this check once in a
day.
When changing the location
no further test is required.
4. Press the Reset key again – the indicator panel will
light up orange.
5. The machine can be startet.
Switch on
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Check that the PRCD is operative: indicator panel orange.
Press the green button ( I ) on the
switch. At the same time, check
whether the rotating direction of the
cutting-off wheel corresponds to
the indicated rotational direction on
the protection cover (arrow).
If there is a power cut, the machine switches off automati-
cally. To switch on again, first press the red and then the
green button.

Switching off

Press the red button ( 0 ) on the switch.

Working instructions

Before commencing work, ensure the
following:
Workplace tidied?
Is the radial tile cutter stably mounted?
You may not start to operate the machine until you have
read these operating instructions, observed all the
instructions given and installed the machine as described!
Working with the radial tile cutter
Keep your hands always in a safe distance to the
rotating cutting-off wheel.
Do not start working before the cutting-off wheel has
reached its maximum rotational frequency.
Pay attention to that the cooling water pump (26) washes
water to the cutting-off wheel.
Only workpieces which have been securely mounted and
aligned can be processed.
Ensure that you always comply with the safety
instructions given on p. 13 ff.

Adjustments on the radial tile cutter

Replacing cutting-off wheel
Before replacing the cutting-off wheel pull
out the power plug.
Do not use any damaged cutting-off wheels or such which
have changed their shape.
Only use sharp cutting-off wheels.
15