Troubleshooting - Parkside Performance Pphsa 40-Li C3 Montage-, Bedienungs- Und Sicherheitshinweise

˜ Troubleshooting
Problem
The product does not
start .
The product works
with interruptions .
The safety cutter
bar becomes hot .
2 ] [
Bad cutting result
Possible cause
The battery packs
[ 9 ]
inserted .
The battery packs
[ 9 ]
discharged .
The on/off switch or the safety
[ 7 ]
switch is defective .
[ 21 ]
The motor is defective .
Internal loose contact
The on/off switch or the safety
7 ] [
switch is defective .
21 ] [
The safety cutter bar
[ 2 ]
There are nicks on the safety cutter
bar .
[ 2 ]
Too much friction due to lack of
lubrication
Too much friction due to lack of
lubrication
The safety cutter bar
2 ] [
The safety cutter bar
2 ] [
Bad cutting technique
Solution
are not Insert the battery packs
"Inserting and removing the
battery packs") .
are Charge the battery packs
"Charging the battery pack") .
Contact our Service Centre (see
"Service") .
Contact our Service Centre (see
"Service") .
is blunt . Have the safety cutter bar
sharpened or replaced .
Contact our Service Centre (see
"Service") .
Lubricate the safety cutter bar
Lubricate the safety cutter bar
is blunt . Have the safety cutter bar
sharpened or replaced .
Contact our Service Centre (see
"Service") .
is dirty . Clean the safety cutter bar
(see "Cleaning") .
see "Cutting techniques"
(see
[ 9 ]
(see
9 ] [
2 ] [
.
2 ] [
.
2 ] [
2 ] [
2 ] [
GB 21