Cleaning; Maintenance - Parkside Performance Pphsa 40-Li C3 Montage-, Bedienungs- Und Sicherheitshinweise

Have any repair and maintenance work
o
that is not described in these instructions
carried out by our Service Centre (see
"Service") . Only use original replacement
parts .
˜ Cleaning
WARNING! Risk of electric shock!
m
Never spray down the product with
u
water .
m NOTICE! Risk of damage to the
product!
Chemical substances may attack the
u
plastic parts of the product . Do not use
any cleaning agents or solvents .
Keep the ventilation slots, motor housing,
o
front handle and handle
[ 4 ]
a damp cloth or brush to do this .
Cleaning and care of the safety cutter
bar
2 ] [
Tools and aids required:
o
–
Cloth
–
Care oil spray
Care after each use:
o
–
Remove any green cuttings that are stuck .
–
Clean the safety cutter bar
oily cloth .
–
Maintain the safety cutter bar
care oil spray .
˜ Care and repair
Before each use: Check the product for
o
obvious defects such as loose, worn or
damaged parts . Ensure that the screws in
the safety cutter bar
Check the stop protection
o
cutter bar and hand protection
2 ] [
damage and correct fit . Replace these parts
if necessary or have them repaired by our
Service Centre (see "Service") .
clean . Use
[ 8 ]
with an
[ 2 ]
with a
2 ] [
are firmly in place .
2 ] [
, safety
[ 1 ]
for
3 ] [
You can smooth out slight nicks on the
o
cutting teeth yourself . To do this, sharpen
the cutting edges with an oil stone . Only
sharp cutting teeth provide a good cutting
performance .
A blunt, bent or damaged safety cutter
o
bar must be replaced .
[ 2 ]
Have any work that is not described in this
o
user manual performed by our Service
Centre (see "Service") . Only use original
parts .
˜ Storage
Always store the product
o
–
clean,
–
dry,
–
protected against dust,
–
in the blade encasing
–
out of the reach of children .
The storage temperature for the battery
o
packs and the product is between 0 °C
[ 9 ]
and +45 °C . Avoid extreme cold or heat
during storage to ensure the output of the
battery packs is not adversely affected .
Before storage: Remove the battery
o
packs from the product .
9 ] [
˜ Maintenance
˜ Replacing the hand
protection
(Fig . C)
Tools and aids required:
o
–
Hand protection
parts/Accessories")
–
Phillips screwdriver (not included)
1 . Loosen the 2 screws
protection with a Phillips screwdriver .
3 ] [
2 . Remove the damaged hand protection
3 . Fasten the new hand protection
2 screws .
22 ] [
,
13 ] [
(see "Replacement
3 ] [
on the hand
22 ] [
3 ] [
with the
3 ] [
GB 19
.