Before Operation - Parkside Performance Pphsa 40-Li C3 Montage-, Bedienungs- Und Sicherheitshinweise

Trimming shaped hedges
(Fig . D)
NOTE
Trim hedges in a trapezoidal shape
u
to prevent the lower branches from
becoming bare . This corresponds to
the plant's natural growth and allows
hedges to thrive optimally . Only the new
annual shoots are reduced during cutting
to allow dense branching and good
protection of privacy .
Trim plants while they are young to
u
achieve the desired shape . The main
shoot should be left intact until the hedge
has achieved the intended height . Cut all
other shoots to half their size .
1 . Trim the sides of the hedge . To do so,
move the product from bottom to top in the
direction of growth . If you cut downwards,
thinner branches will move outwards which
may cause thin patches or gaps .
2 . Trim the top edge as desired: straight, roof-
shaped or round .
Cutting free-growing hedges
Free-growing hedges are not to be trimmed
o
into shapes but still need to be regularly cut
to ensure they do not become too tall .
˜ Before operation
Carry out the following steps before each
operation . This will guarantee long and reliable
use .
Search the hedges and bushes for foreign
o
objects, e .g . wire fences and hidden wires .
Check the product before each use for
o
obvious defects such as loose, worn or
damaged parts . Ensure that the screws in
the safety cutter bar
Do not cut with a dull or worn safety cutter
o
bar , otherwise you will overload the
2 ] [
motor and gears of the product .
are firmly in place .
2 ] [
Check the covers and protective devices for
o
damage and correct fit .
–
Stop protection
–
Hand protection
To replace the stop protection
case of damage to the hand protection
contact our Service Centre (see "Service") .
˜ Inserting and removing the
battery packs
m WARNING! Risk of injury due to
unintentional start-up!
Only insert the battery packs
u
the product is fully prepared for use .
m NOTICE! Risk of property
damage and damage to the
product!
An incorrect battery pack can damage
u
the product and the battery pack .
Inserting the battery packs
Push both battery packs
o
guide into the battery pack holder
will hear the battery packs click into place .
Removing the battery packs
1 . Press and hold the release button
battery packs .
[ 9 ]
2 . Pull the battery packs
pack holder .
[ 6 ]
˜ Setting the stroke rate
Press the button
o
The relation between the digits 1/2/3 on
o
the level display
20 ] [
minute is shown in the following table:
Level
1
2
3
1 ] [
3 ] [
or in
[ 1 ]
[ 3 ]
once
9 ] [
along the
9 ] [
. You
[ 6 ]
on the
10 ] [
out of the battery
9 ] [
to set the stroke rate .
19 ] [
and the stroke rate per
Stroke rate
2,000 min
‒1
3,000 min
‒1
3,600 min
‒1
GB
,
17