Operation; Cutting Techniques - Parkside Performance Pphsa 40-Li C3 Montage-, Bedienungs- Und Sicherheitshinweise

˜ Charging the battery pack
m NOTICE! Risk of damage to the
battery pack
Do not expose the battery pack
u
direct sunlight for long periods and do
not place it on a radiator . Observe an
ambient temperature of max . +50 °C .
NOTE
You can find detailed instructions in the
u
user manual of the charger
If the battery pack
u
it to cool down before charging .
1 . Remove the battery pack
product .
2 . Push the battery pack
slot of the charger
3 . Connect the charger
4 . After charging: Disconnect the charger
from the socket-outlet .
5 . Pull the battery pack
charger .
[ 15 ]
Control LEDs on the charger
Green Red
Lights up —
— Lights up
— Flashes
Flashes Flashes
16 GB
!
9 ] [
to
[ 9 ]
.
[ 15 ]
is still warm, allow
9 ] [
from the
[ 9 ]
into the charging
9 ] [
.
15 ] [
to a socket-outlet .
15 ] [
15 ] [
out of the
9 ] [
15 ] [
Meaning
Fully charged
Stand-by mode (no
battery pack
9 ] [
inserted)
Charging
Battery pack is
9 ] [
overheated
Battery pack is
9 ] [
defective
˜ Operation
˜ Working with the product
m WARNING! Risk of injury!
Pay attention to the following instructions .
u
m NOTICE! Risk of damage to the
safety cutter bar
While cutting, make sure that you do not
u
touch any objects, such as wire fences or
plant supports .
Always wear sturdy shoes, long trousers,
ear protection, work gloves and protective
goggles when operating the product .
The product is only intended for work where
you are standing on the ground and not on
a ladder or other unstable surface .
Do not use the product if the on/off
switch or the safety switch
[ 7 ]
damaged .
If the safety cutter bar
with solid objects, switch the product
off immediately and remove the battery
packs . Only then should you remove the
[ 9 ]
object .
Avoid over-stressing the product while
working .
˜ Cutting techniques
Cut out thick branches in advance using
o
lopping shears .
The double-sided safety cutter bar
o
enables trimming in both directions, or via
pendulum movements from one side to the
other .
When cutting vertically, move the product in
o
a steady forward motion, or up and down
in an arch-shaped motion .
When cutting horizontally, move the
o
product in a sickle-shaped motion to the
edge of the hedge so that cut branches fall
to the ground .
Tie cords to achieve long, straight lines .
o
!
2 ] [
is
21 ] [
becomes jammed
2 ] [
2 ] [