Environmental Protection; Before Startup; Unpacking; Start Up - Kärcher HD 600 Betriebsanleitung

Environmental protection

The packaging material can be re-
cycled. Please do not place the
packaging into the ordinary refuse
for disposal, but arrange for the
proper recycling.
Old appliances contain valuable
materials that can be recycled.
Please arrange for the proper recy-
cling of old appliances. Batteries,
oil, and similar substances must not
enter the environment. Please dis-
pose of your old appliances using
appropriate collection systems.

Before Startup

Unpacking

– Check the contents of the pack before
unpacking.
– In case of transport damage inform ven-
dor immediately
Check oil level
Cut off tip of oil container cover
Check oil level in the oil tank.
Attaching the Accessories
Mount the nozzle on the spray pipe
(markings on the adjustment ring at the
top).
Connect ray tube to hand spray gun

Start up

Electrical connection

Warning
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
12
English
The minimum fuse rating required at the
socket outlet is (see technical specifica-
tions).
It is recommended that you connect this de-
vice to a socket that has a 30 mA protection
switch against wrong currents.
Check the power cord with mains plug for
damage before every use. If the power cord
is damaged, please arrange immediately
for the exchange by an authorized custom-
er service or a skilled electrician.
The plug and coupling of the extension ca-
ble used must be watertight.
Use the extension cord that has an ade-
quate cross-section (see "Technical Data")
and unwind it fully from the cable drum.
Unsuitable extension cables can be haz-
ardous. Only use extension cables out-
doors which have been approved for this
purpose and labelled with a sufficient cable
cross section:
For connection values, see type plate/tech-
nical data.
Water connection
Connection to the water supply
Warning
Observe regulations of water supplier.
The appliance is not suited for use in the
drinking water supply network. It is neces-
sary to install a suitable system separator
from Kaercher, if the device is to be used in
the drinking water supply network.
For connection values refer to technical
specifications
Connect the supply hose(minimu length
7.5 m, minimum diameter 3/4") to the
water connection point of the machine
and at the water supply point (for e.g. a
tap).
Note
The supply hose is not included.
Open the water supply.