Maintenance; Cleaning; Removal And Refitting Of Wheels For Bikes With A Rear Wheel Motor - Trek Ride Plus Bedienungsanleitung

m
Four zeros will appear, with the first zero blinking.
Enter the appropriate code by pressing button '+' for a higher value, '-' for a lower value. Press
button 'On/Off' to select a value and move to the next digit. After entering the correct value for the
fourth digit, press button 'On/Off' to move into the chosen menu. In the programming menu,
buttons '+' and '-' will move to a higher or lower value. Pressing button 'On/Off' will save the entry
and move you to the next step, or back to the regular display.
Codes:
2001
2004
2009
2 0 1 1
3 7 7 1

5. Maintenance

After the first two to three weeks of use, or 300 km, have your dealer check the spokes in the rear
wheel. The motor is of the 'brushless' type and requires no maintenance.
Check the connections of the system every two to three months. Make sure that no dirt or moisture
can get into the 'docking station' (connector) when the battery pack is not on the bike. If you notice
anything like this, clean with a smooth, dry brush.

5.1 Cleaning

When cleaning the bike, use a sponge and/or a soft brush. For the battery pack case, a damp cloth
suffices. Use little water. Keep water away from the electrical connections.

5.2 Removal and refitting of wheels for bikes with a rear wheel motor

Removal and refitting of the rear wheel is best left to your dealer. If you are forced to do it yourself,
follow the instructions.
• Removal of the rear wheel
1. Make sure that the system is switched 'Off'.
2. Change to the highest gear.
3. Remove the battery pack from its docking station.
4. Unplug the connectors of the motor at the left hand side of the hub. Make sure that both cables
are unplugged. (see photo).
5. D isconnect the rear brake:
-V-brakes, Magura brakes: release the rear brake.
- Roller brakes: unhook the cable and housing stop from
6. Loosen and remove the axle nuts.
7. S lide the wheel forward in the dropouts until the wheel
can be removed.
8. R emove the chain from the sprocket.
9. Remove the wheel.
34
Downloaded from www.Manualslib.com
aintenanCe
to switch between miles and kilometers.
to set the time.
to swap the function of the buttons from left to right and vice versa.
to change the display language. Use button to scroll through the languages.
to set the correct wheel diameter.
Notice. Do not use a jet-wash. The powerful water-jet may damage the electronics.
the brake. Undo the reaction arm bolt.
manuals search engine