Trek Ride Plus Bedienungsanleitung Seite 22

• Changing the language option of the controller
The RIDE+ Pro controller allows you to change the language that is displayed on the screen.
See the part 'programming' later in this manual to set the correct language.
• Adjusting the contrast of the controller's display
Hold the
• Removing and installing the RIDE+ Pro Controller
To remove the RIDE+ Pro Controller from the bike, press the catch of the holder and slide the
controller off towards the rear. To install the RIDE+ Pro Controller onto the handlebar, align the
controller with its clamp and slide the controller forward until it clicks. To prevent loss of riding
information, please make sure that the controller is switched off before it is removed from the bike.
• Unintended removal of Controller out of its dock
If the controller is moved off its clamp while the system is active ('On'), the system will no longer
assist, even when the controller is replaced into its clamp. Please select the correct level of
assistance again to reactivate the system.
• Using the RIDE+ Link
Most bikes with the RIDE+ Pro controller are equipped (or can be equipped)
with the RIDE+ Link.
This device is mounted either the right or left side of the handlebar and can
be used to regulate the following functions without moving your hands off
the handlebar:
,
1• '
2• '+' button
3• '-' button
4• Throttle button For Pedelecs: walk assist up to 3 or 6 km/h (pedaling not needed)
The red throttle button on the RIDE+ Link remote is a convenient help to move the bike without
pedaling (up to 4 km/h) walking next to the e-bike.
Caution. Beware of unintended use of the throttle button when the system is switched on.
Downloaded from www.Manualslib.com
button pressed and then press the '+' or '-' button to adjust the contrast of the display.
' button Switch light On/Off
Increase assist level (or decrease regeneration level)
Decrease assist level (or increase regeneration level)
For fast E-bikes: assist up to 25 km/h (pedaling not needed)
manuals search engine
i u
nstruCtions For
4
se
1
2
3
23