Busch+Müller Core Highbeam Montage- Und Bedienungsanleitung Seite 20

Charge indication:
Should the battery be further depleted, both a blue and red LED will pulse together. It is then vital that
the headlight battery be charged.
Once the battery level sinks below a certain capacity, the headlight
light mode.
WARNING if an automatic switch into low-power mode due to low battery level takes place, the he-
adlight may remain alight for appr. 1 hr before going out. This may vary due to external temperature
1
differences, and an abrupt extinguish may occur. This can lead to serious accidents and injury so always
charge the light battery at the latest when the red LED illuminates.
7.2. Operating the headlight
via Bluetooth button 5.2 Blucon
The headlight (low beam) is switched on and off using the button
The high beam function is switched on and off by briefly pressing the Bluetooth button
the high beam symbol. When the high beam is switched on, the LED on the control unit lights up blue.
The buttons on the Bluetooth button 5.2 Blucon are factory-set with the following functions:
Spotlight 1 on/off: Press and hold the mode button
Mode change (3 different driving modes): Briefly press the mode button
High beam function on/off: Briefly press the high beam button.
38
1 will switch into the next lower
on the headlight.
5.1
Blucon with
5.2
.
.
NOTICE If the battery in the Bluetooth button
weak, the headlight automatically switches to low beam. The high beam function can no longer
be activated.
!
If a low beam LED fails, the headlight can no longer be switched on. If the high beam LED fails,
the headlight will illuminate in low beam mode.
7.3. Charging the battery
The headlight contains a replaceable Lithium-Ion battery of 3.000 mAh. Before first use, the
1
battery must be charged. To charge the battery open the cap at the rear side of the headlight
1 . Connect an (optionally available) USB-C cable to the port revealed. Connect the 2nd end of
the USB cable to the B+M USB - charger (also optionally available), a standard USB – charger
or a computer USB port. During the charging process, the charge level indicator will display the
charge level of the headlight battery. As soon as the battery has reached full charge, stop the
charging process.
During the charging process, the headlight
the charger used.
At slow charging speed, the left LED (blue) in the switch
At medium charging speed, the left and central LED's (blue) in the switch
At fast charging speed, all three LED's (blue) in the switch
5.2 Blucon is not replaced in time and is too
1 will show the charging speed. This will depend on
5.1 is active.
5.1 are active.
are active.
5.1
39