Busch+Müller Core Highbeam Montage- Und Bedienungsanleitung Seite 17

!
Please note: The locking barrel can be used for shallow or deep insertion to suit handlebar diameter
(simply invert as required).
!
If the rubber ring supplied is too thick for your handlebar, please contact our service team. (Mail:
service@bumm.de, Tel.: +49 2354 915-7111) We will send you a thinner rubber ring free of charge.
!
Insert the headlight 1 into the upper plate of the headlight bracket
the direction of travel) and firmly push it into place until it audibly engages. Be sure to check that it is
1
securely seated. To remove the headlight
1
right of the headlight in the direction of travel), while firmly holding the headlight
to the left. We exclude liability for any damage caused by disconnection and drop-falling, e.g. because
the headlight 1 was not held tight while it was removed.
Adjustment:
1
Vertically: The headlight can be adjusted vertically (e.g to adjust for handlebar angle) by tilting
around the rubber ring.
Horizontally: The headlight 1 can be swivelled (to a limited extent) to the left or right on the rubber
ring (eg. to centre beam on the roadway).
In both cases, the locking screw of the bracket must be loosened and after adjustment re-tightened.
32
2 from the left (looking in
2
, press the release button on the bracket
1
6.4. Suspended mounting IXON Core Highbeam
Should assembly with the standard handlebar bracket not be preffered, a suspended mount
for the headlight
cockpit situation (but not inverted) by using one of a number of other busch+müller brackets
instead of the one supplied.
One that is often used is:
481GPPB for Assembly on e.g GoPro, Garmin or selected Wahoo-Adapter.
(located to the
For further bracket options please consult our spare parts shop: www.bumm-shop.de.
and pull it off
See 6.5. Assembly and connection of bluetooth button Blucon
To install, attach the Bluetooth button
handlebars using the rubber fastener provided, so that it can be operated without having
to take your hand off the handlebars. Can be installed on handlebars with a diameter of 22
to 32 mm.
The headlight
During initial operation, the headlight
selves automatically. During the connection process, the bluetooth symbol on the bluetooth
button lights up blue. The headlight
5.2
5 minutes after switching on. The headlight
1 be used. This can be mounted under the handlebar to suit the bicycle
5.2 Blucon securely and within easy reach to the
1 is designed to be paired with any Blucon bluetooth button
1 and bluetooth button
can be connected to a Bluetooth button
1
1 can be connected to a Bluetooth button
5.2 .
5.2 connect and save them-
for
5.2
5.2
33