Busch+Müller Core Highbeam Montage- Und Bedienungsanleitung Seite 18

for 5 minutes after switching on. If a Bluetooth button
may be due to the following reasons:
The Bluetooth button is already connected to another headlight.
5.2
The spotlight 1 has memorised a different button for control. Stored buttons can be deleted via the
app or by resetting the firmware.
If the connection is successful, the blue LED of the Bluetooth symbol on the bluetooth button
off, and the bluetooth symbol on the headlight
To disconnect a connected Bluetooth button
succession. Alternatively, this can be done via the busch+müller app. For more information about the
app, see '7.6. busch+müller app'.
34
5.2 does not connect to a headlight
lights up blue.
1
5.2 , switch the headlight 1 on and off five times in quick
7. Operation
1 , this
7.1. Operating the headlight via button
Switch incl. light level indicator:
To switch ON/OFF: push switch
To switch between Low-Power/Mid-Power/High-Power modes: Short press to switch
Low-Power 15 Lux, run-time more than 18 hours with maintained brightness.
Mid-Power 35 Lux, run-time more than 6.5 hours with maintained brightness.
5.2 goes
High-Power: 70 Lux, run-time more than 2.5 hours with maintained brightness.
The light level mode is automatically switched down to low power at reduced battery charge
level.
Activate high beam function: Briefly press the Bluetooth button
tooth button and in the left headlight bar will illuminate.
Deactivating the high beam function: Briefly press the Bluetooth button
LED on the Bluetooth button and in the left headlight bar go out.
5.1
5.1 for 2 seconds.
. The blue LED on the Blue-
5.2
5.2
5.1 .
. Display: The blue
35