Problem Chart - EuroLite DMX Scene Setter Bedienanleitung

A: open loop mode:
TRANSMITTER
MIDI OUT
B: closed loop mode:
TRANSMITTER
MIDI IN
MIDI OUT
NOTE: when sending file dump in open loop mode, you should set up receiving mode for the receiver,
otherwise receiving is disable
7) When the power voltage is too low ,the display show LOP, now you should check whether the power is
OK. It is normal that LOP is appeared for a short while just after power is turned on.
20. MIDI RUN
1) If MIDI data is not received within 10 minutes, the channel and program turned on by MIDI will be cleared.
2) When sending or receiving file dump, the device ID is 55H. All information (include System Exclusive)is
sent or received in file dump.
You can send SCENE program to storage or another unit, you can also receive SCENE program from
storage or another unit.
3) this unit sends or receives NOTE information ,relevant functions is as follows:
NOTE NUMBER VELOCITY
22-69 PROGRAM MASTER
70-93 CHANNEL DIMMER
94
95
96
97
98
99
100
101
102

7. PROBLEM CHART

PROBLEM
No power.
RECEIVER
RECEIVER
MIDI OUT
FUNCTION
TURN ON/OFF PROGRAM 1-48
TURN ON/OFF CHANNEL 1-24
FULL ON
DARK
HOLD
TURN ON/OFF AUDIO CHASE
CHASE SCENES
DOUBLE PRESET MODE
SINGLE PRESET MODE
STEP CHANGE
BLACK OUT
CAUSE
The power unit is not connected.
MIDI IN
MIDI IN
Check the connection cable of the
power unit and any extension-cables.
23
REMEDY