Werbung
Commissioning
Only put the device into operation when you have become familiar
with the features and these operating instructions. Check all con-
nections for correctness once again.
Do not listen to excessively loud music for long periods of time as
your hearing may be impaired. This applies in particular to listen-
ing to music through headphones.
Switching mixer on/off
When switching he mixer on and off, non-observance of the order
described in the following could damage the loudspeakers or the
amplifier.
Switching on
• Make sure that all channel faders are set to the minimum volume (channel fader
right down).
• First switch on the reproduction devices which are connected to the mixer.
• Switch on the mixer using the switch "POWER"(1). The operating indicator will light
up.
• Switch on the connected amplifier and the recording device (connected to the
REC jacks). This device is now ready for operation.
Switching off
• To switch off the mixer, turn the volume of the amplifier first of all to minimum.
• Switch off the amplifier.
• Then switch off the mixer using the mains switch POWER (24) and then the repro-
duction devices (record player, CD player etc.).
• If you do not require the mixer for a longer period, pull out the plug-in power unit
from the socket.
Select input
Select the desired inputs using the input selection switches (19).
Minimise the volume using the corresponding channel fader
before an input selection switch is changed over. Due to the dif-
ferent volumes of the input sources, sudden, excessive volume
could otherwise be the result.
42
(13) Channel faders
Using this slide control, you can set the level of the individual channels. The maxi-
mum level of volume is achieved at the control position "10", the minimum level at
position "0". One channel fader is available per channel.
DJ MIC fader = mono fader for the microphone input
CH1 fader = stereo fader for the PHONO CH1 and MIC CH1 input
CH1 fader = stereo fader for the PHONO CH2 and MIC CH2 input
CH1 fader = stereo fader for the PHONO CH3 and MIC CH3 input
(14) Basses sound control "LOW"
Using these controls, you can set the basses for each of the fader channels DJ MIC,
CH1, CH2 und CH3.
Left control stop = maximum reduction of the basses
Right control stop = maximum increase of the basses
Central position = no influence of the signal through the control
(15) Medium tone sound control (MID)
Using these controls, you can set the medium tone level for each of the fader chan-
nels DJ MIC, CH1, CH2 und CH3.
Left control stop = maximum reduction of the mid tones
Right control stop = maximum increase of the mid tones
Central position = no influence of the signal through the control
(16) Trebles sound control (HIGH)
Using these controls, you can set the trebles for each of the fader channels DJ MIC,
CH1, CH2 und CH3.
Left control stop = maximum reduction of the trebles
Right control stop = maximum increase of the trebles
Central position = no influence of the signal through the control
(17) Talkover switch
Using this switch, the signal of the channels CH1, CH2 and CH3 can be reduced dur-
ing a microphone announcement.
Switch position "TALKOVER" = talkover feature is switched on
Switch position "OFF" = talkover feature is switched off
(18) Input level control GAIN
Using these rotary controls, you can adapt the mixer inputs to the output level of the
source of signal concerned (record player, CD player etc.).
Position "0" = mixer input is very insensitive
Position "10" = mixer input is very sensitive
35
Quicklinks ausblenden:
Werbung
Kapitel
