Setting The Timer Mode And Print Trigger - Renkforce Rf-Hip-001 Bedienungsanleitung

16.4 Setting the timer mode and print trigger

Set the timer mode and match it with a print trigger to suit your operational needs.
Start Signal Synchronization
Manual switch (key) Timer
Photoelectric switch (sensor) Timer
Distance switch (distance) Timer
Timed re-spray (timer) Timer
Install the ink cartridge and power on the machine.
1. In the menu, go to "Settings > Print".
2. Set the "Sync Mode" to "Timer".
3. Under "Start signal" select the required start signal that triggers the print job.
4. Perform further configurations as available and required.
The printer is ready to print.
Æ
Print start signal
Press the print button again (after preparation)
Object detection by connected photoelectric sensor
Encoder rolls the set fixed distance
Wait for the set fixed time interval to elapse
Typical Usage Context
Handheld operations
Assembly line use; sensor-triggered cyclic printing
Handheld operations requiring a fixed starting offset
Continuous or cyclic printing jobs
49