Modes And Print Start Signals; Setting The Encoder Mode And Print Trigger - Renkforce Rf-Hip-001 Bedienungsanleitung

16.2 Modes and print start signals

The printer operates in one of two operation modes:
Encoder mode
Timer mode
Operation modes can be combined with 4 print trigger types:
Manual switch (key)
Photoelectric switch (compatible photoelectric sensor)
Distance switch (distance) [ must be paired with encoder ]
Timed re-spray (timer) [ must be paired with timer mode ]
Different mode/trigger type combinations allow you to adapt the printer to your operational needs.

16.3 Setting the encoder mode and print trigger

Set the encoder mode and match it with a print trigger to suit your operational needs.
Start Signal Synchronization
Manual switch (key) Encoder
Photoelectric switch (sensor) Encoder
Distance switch (distance) Encoder
Timed re-spray (timer) Encoder
1. In the menu, go to "Settings > Print".
2. Set the "Sync Mode" to "Encoder".
3. Under "Start signal" select the required start signal that triggers the print job.
4. Perform further configurations as available and required.
The printer is ready to print.
Æ
48
Print start signal
Press the print button again (after preparation)
Object detection by connected photoelectric sensor
Encoder rolls the set fixed distance
Wait for the set fixed time interval to elapse
Typical Usage Context
Handheld operations
Assembly line use; sensor-triggered cyclic printing
Handheld operations requiring a fixed starting offset
Continuous or cyclic printing jobs