Playing Back Ipod/Iphone - Yamaha YRS-700 Bedienungsanleitung

Playback features
y
1)
• Connect when this unit is in standby mode.
• For details on how to connect and set up the YDS-12 and YID-W10,
refer to manuals supplied with them.
y
2)
When using YDS-12, YDS-11, or YDS-10 with the video pin cable
(supplied) to connect the VIDEO OUT jack of this unit to the VIDEO
INPUT jack of the TV, you can display iPod/iPhone video on the TV.
14
En

Playing back iPod/iPhone

You can play music stored in iPod/iPhone connected to Yamaha
Universal Dock for iPod (optional YDS-12, etc.) or Wireless
System for iPod/iPhone (optional YID-W10).
1
Insert the iPod/iPhone into the Yamaha
Universal Dock for iPod or Wireless
System for iPod/iPhone connected to the
1)
DOCK terminal.
Place it as far as possible from this unit to avoid the noise.
2
Playback iPod/iPhone by selecting dock
input by pressing
3) Note
• Some features may not be available depending on the model or the
software version of your iPod/iPhone.
• For details about the messages displayed on the front panel display of
connected iPod/iPhone, refer to "iPod/iPhone (☞p. 26)" in
"Troubleshooting".
• Be sure to set the volume to minimum before docking or removing
your iPod/iPhone.
• To set the playback volume higher than the maximum volume of the
iPod/iPhone, use this unit's remote control to control the volume.
2)
To VIDEO INPUT of TV
(only when YDS-12/YDS-11/
YDS-10 is used)
YDS-12, etc.
3)
DOCK key.