Troubleshooting - Sony walkman RDP-NWR100 Bedienungsanleitung

Cleaning the nonslip sheet
Remove the nonslip sheet from the battery cover
and wash it in water.
To remove the nonslip sheet
Push the arrowed part and remove the nonslip
sheet.
To reattach the nonslip sheet
Align the protrusions of the nonslip sheet with the
slots of the battery cover, and press down the
arrowed parts firmly.

Troubleshooting

Should you encounter a problem with the system,
find your problem in the troubleshooting checklist
below and take the indicated corrective action.
If the problem persists, contact your Sony dealer
or Sony Service Center.
You cannot operate the "WALKMAN."
If the HOLD switch of "WALKMAN" is set to

the HOLD position, unset it.
Your "WALKMAN" is for touch panel

operation. You can only operate a
"WALKMAN" compatible with this unit.
The sound is distorted.
Set the sound mode of the "WALKMAN" to

[Off] or a flatter setting.
No sound
Make sure your "WALKMAN" is securely

connected to the WM-PORT plug.
After prescribing the remedies above, if the
problem still persists, press the RESET button of
your "WALKMAN" to reset it.
Volume is quiet.
Press the VOL + button to turn up the volume.

Replace the batteries with new ones.

The stand becomes detached.
Install the stand to the unit by the procedure
below.
 Fit the upper connections of the stand in the
slots on the rear of the unit.
 Press down the stand until you hear a click.
11
GB