Connections; Connecting To Line Output (Pin Jack) Terminal(S) Of The Amplifier - Yamaha NS-SW1000 Bedienungsanleitung

Choose one of the following connection methods most suitable for your audio system.
Choose this method if your amplifier has line output (pin jack) terminal(s).
1
( page 5)
Choose this method if your amplifier has no line output (pin jack)
2
terminals. ( page 6)
Note
Audio signals input from the /MONO and
Connecting one subwoofer
Connect the SUBWOOFER (or LOW PASS, etc.) terminal on the rear of the amplifier (or
AV receiver) to the /MONO INPUT2 terminal of the subwoofer using a commercially-
available Mono pin cable (1).
Alternatively,
When connecting the subwoofer to the SPLIT SUBWOOFER terminals (featuring L and R
channels) on the rear panel of the amplifier, use a commercially-available Audio pin
cable (2) to connect the /MONO INPUT2 terminal to the "L" side, and the
terminal to the "R" side of the SPLIT SUBWOOFER terminals.
Subwoofer
1
Amplifier or
receiver
5
En

CONNECTIONS

Connecting to line output (pin jack) terminal(s) of the amplifier

1
INPUT 2 terminals on the subwoofer will not be output from the OUTPUT (TO SPEAKERS) terminals.
INPUT2
2
1
Mono pin cable
2
Audio pin cable
Note
• Unplug the subwoofer and other audio/video components before making connections, and do
not plug them in until all connections are completed.
• Connecting methods and terminal names on your component (such as an amplifier or receiver)
may be different from those used in this book. Please refer to the owner's manual that came
with your component.
• All connections must be correct, that is to say L (left) to L; R (right) to R; "+" to "+" and "–" to "–".
Connecting two subwoofers
Subwoofer
1
Amplifier or
receiver
Connecting to the INPUT3 (LFE) terminal
If your amplifier (or receiver) can cut off high frequencies
from signals sent to the subwoofer, connect the amplifier to
the subwoofer's INPUT3 (LFE) terminal.
This will promote higher sound quality because the signal
routing in the subwoofer is shortened by bypassing the built-
in HIGH CUT circuit.
Subwoofer
1
1
Mono pin cable