Maintenance And Cleaning - Scancool Bb211Slbb Bedienungsanleitung

Cleaning-Display coolers
WARNING
To avoid the risk of electric shock or personal injury from the rotating circulation fan, always remove
the power cord before cleaning.
Never spray water directly on the product or wash with water, as a short circuit may occur and
electrical leakage.
WARNING: Do not use electrical products inside the product storage compartment unless they are of
the type recommended by the manufacturer.
Exterior and interior
Wipe with a soft, dry cloth.
If the inside is very dirty, use a cleaning product approved for the purpose, then dry off with a cloth.
WARNING: Do not spray water directly on the product and do not wash with water. There may occur
short circuit and electric shock. Clean the product regularly to maintain it clean. Never use polishing
powder, soap powder, benzene, oil or hot water as these will damage the painting and plastic
components.
How to clean the capacitor
(This section is for all products with a visible condenser)
It is important to clean the condenser coil regularly every 2-3 months.
Heavy accumulation of dust on the condenser can lead to reduced cooling efficiency, increased energy
consumption and possible compressor damage.
Follow these steps to clean the condenser:
1 Turn off the power and pull out the plug.
2 Remove the front panel to get access to the condenser.
3 Use a vacuum cleaner or a soft brush in a vertical movement to clean the condenser.
Check after cleaning
To guarantee safety, the following points must be checked and carried out after cleaning.
• Is the plug seated properly in the appropriate socket power outlet?
• Confirm that the connector is not abnormal hot.
• Check the cord for cracks and damage.
• If the slightest irregularity is observed, you must contact the dealer where you purchased this
device, or our customer service.

Maintenance and cleaning

English 11