Klarstein RUBYBAR Bedienungsanleitung Seite 20

EN
20
Control panel operation
1. Turn the unit on: Touch the On/Off button
shows P0.
2. Adjust the heat level: Touch the
and P9. The operation lamp lights up and heater starts to operate.
3. Setting the timer: The operation light will illuminate. Touch the control panel
when the display is flashing '00'. When you touch the
set the timer for 0 to 24 hours. After the timer is set,
the button for three seconds to clear the timer. If you touch the button
during operation, the heater will go into standby.
Remote control operation
WiFi operation: The WiFi light will flash, indicating that the WiFi is not connected.
to be connected. To connect start the Klarstein App, enter the local WiFi account
password, and search to add device. After being connected, the WiFi lamp lights
constantly.
to turn on the heater. The display
button to adjust the heat level between P0
The remote control has a similar operation as
the control panel on the unit. For changing the
heating level, you use the buttons + and –.
button now you can
flashes. Press and hold