Installation - Klarstein Rubybar Bedienungsanleitung

EN
18

INSTALLATION

Before the installation, these matters need to attention
1. Products should be put down gently
2. Acid and alkali environment installation is not recommended.
3. The product must be grounding
4. The products are required to check the product brand mark on the voltage
and the local voltage whether conform.
5. Ensure the power rating should have sufficient current carrying capacity.
Installation steps of the wall-mounted heater
These precautions need to be taken before installation
• The product should be put down gently;
• Do not install in acid and alkali environment;
• The product must be grounded.
• Check whether the nameplate mark on the product voltage conforms to the
local voltage.
• Ensure that the cable socket has sufficient current carrying capacity.
The installation position of the product should be placed 1.8 m from the ground,
with a minimum distance of 0.5 m from the bottom of the ceiling, roof or other
covering and a minimum distance of 0.5 m from the walls on both sidesFor the
wall-mounted infrared heater installation step.
1. Installation location, use percussion drilling to
make three diameter 8 mm round holes.
2. Insert the three plastic wall anchors to the
three holes.
3. Fixed the bracket by three ST4*35 screws
and make sure the installation points fixed
securely.