Safety Devices; Environmental Protection; Before Startup; Unpacking - Kärcher HD 10/25-4 Cage Plus Bedienungsanleitung

Safety Devices

If the lever on the trigger gun is released
the pressure switch turns off the pump, the
high-pressure jet ist stopped. If the lever is
pulled the pump is turned on again.
The overflow valve prevents the permissi-
ble working pressure from being exceeded.
The overflow valve and pressure switch are
set and sealed at the factory. Setting only
by customer service.
Setting only by customer service.
The motor protection switch switches off
the device if the power consumption is high.

Environmental protection

The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for disposal, but
arrange for the proper recycling.
Old appliances contain valuable ma-
terials that can be recycled. Please
arrange for the proper recycling of
old appliances. Batteries and accumulators
contain substances that must not enter the
environment. Please dispose of your old
appliances, batteries and accumulators us-
ing appropriate collection systems.

Before Startup

Unpacking

– Check the contents of the pack before
unpacking.
– In case of transport damage inform ven-
dor immediately
Assemble the appliance
Install the slider and the hose storage (il-
lustration D).
Check oil level
Read the oil level display when the de-
vice is not running. The oil level must be
above the two markers on the oil reser-
voir.
Activate deaeration of oil container
Cut off tip of oil container cover
Attaching the Accessories
Install nozzle with nozzle screw at the
spray pipe.
Connect ray tube to hand spray gun
For hand-spray guns with threaded con-
nection:
Tighten the high-pressure connection
as required.
For hand-spray guns without threaded
connection:
Lever out the safety clip of the hand-
spray gun using a screw-driver (Picture
A).
Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).
Press the safety clip back into the hand-
spray gun. The hose can be pulled out
max. 1 mm if it has been installed cor-
rectly. Otherwise, it means the disc has
been installed wrongly (picture C).
13
English