Maintenance; Cleaning; Battery; Troubleshooting - Virtufit Rb100 Bedienungsanleitung

ENGLISH
apply consistent pressure to the sensors. Excessively dry or sweaty
hands may result in inaccurate or irregular measurements.

MAINTENANCE

Safe and effective use of this appliance is only possible when it is
correctly installed and properly maintained. It is your responsibility
to ensure the appliance is serviced regularly. Any worn or damaged
parts must be replaced before resuming use. This equipment is
intended for indoor use and storage only. Prolonged exposure to
outdoor conditions or fluctuations in temperature and humidity
may severely affect the electrical components and moving parts.
Always disconnect the power cord before cleaning or performing
any maintenance.
Daily maintenance
• Wipe down the unit after each use to remove sweat and
moisture.
• Ensure the equipment is free from dust and dirt.
• Avoid using harsh cleaning agents and keep the equipment
away from excessive moisture.
Semi-annual maintenance
• Inspect all bolts and nuts connected to moving parts. Tighten
them if necessary.
• Check the movement of all mobile parts and components.
Apply silicone spray if needed.
General cleaning recommendations
• Clean the unit after each training session.
• Use a dry cloth to clean the control panel.
• Use a soft, clean cloth with mild detergent to remove persistent
stains and dirt.
• Store the equipment in a clean, dry environment, away from
direct heat and water sources.
CAUTION!
Repairs must be performed by a qualified technician,
unless otherwise instructed by the supplier or manufacturer.

CLEANING

Regular cleaning significantly extends the lifespan of your equipment.
Keep the appliance free from dust by cleaning it frequently.
Preventative maintenance not only prolongs the life of the equipment
but also helps avoid potential injuries.
For more detailed information, visit: www.virtufit.nl/service/faq

BATTERY

AAA BATTERIES
The display uses AAA batteries, which are replaceable on the back of
the display. The batteries must be inserted correctly.
If the screen is unreadable or only parts of the image work, proceed
as follows:
• Remove the batteries and wait 15 seconds.
• Replace the batteries correctly.
Battery information
• Do not recharge, disassemble, or dispose batteries in a fire.
• Ensure correct polarity (+ and -) when inserting the batteries.
• Always replace all batteries at the same time; do not mix old
and new batteries.
• Use alkaline batteries for optimal performance and longer life.
• Replace the batteries when the display dims or becomes
unresponsive.
Battery replacement
• If the display shows inaccurate readings, battery replacement is
recommended.
• This device requires 2 × AAA batteries.

TROUBLESHOOTING

PROBLEM
Check that all sensor and console cables
are securely connected and undamaged.
The display does not show
any values
If the problem persists, gently adjust the
position of the sensor.
Ensure that all bolts and nuts are properly
tightened.
Squeaking noise from the
exercise bike
Lubricate moving parts if necessary.
This may be caused by incorrectly
mounted pedals.
Firmly tighten the pedal(s).
If the noise continues, remove and
Ticking noise while
remount the pedals correctly:
pedaling
If the problem persists, contact your
supplier.
Wash and dry your hands thoroughly,
then try again.
Check the handlebar cables for damage
Hand sensors are not
and ensure they are properly connected
functioning properly
to the connector.
If the problem persists, contact your
supplier.
Console is not responding Replace batteries.
SOLUTION
•
The R (right) pedal must be
mounted clockwise.
• The L (left) pedal must be mounted
counter-clockwise.
09