Console Overview - Virtufit Rb100 Bedienungsanleitung

ENGLISH
CONSOLE OVERVIEW (FIG. A)
Console buttons
MODE
• Press to scroll through and select the desired display functions.
• Press and hold to reset all values to zero.
SET
• Use this button to manually set target values for Time,
Distance, Pulse, and Calories
• Only when not in scan mode.
RESET
• Press once to reset the current Time, Distance, and Calories
values to zero.
• Press and hold to reset all stored data completely.
Functions
SCAN
• Press the button until "SCAN" appears.
• The console will automatically cycle through the five functions:
Time, Speed, Distance, Calories, and Pulse.
• Each value is displayed for 5 seconds before switching to the
next.
TIME
• Displays the total exercise time from start to finish.
• Press until "TIME" appears, then press
time.
• When the countdown reaches zero, the computer will emit a
10-second signal.
SPEED
• Displays your current exercise speed.
DISTANCE
• Displays the total distance covered during the session.
• Press until "DIST" appears, then press
distance.
• When the countdown reaches zero, the computer will emit a
10-second signal.
CALORIES
• Displays the total calories burned during the session.
• Press
calorie amount.
• When the countdown reaches zero, the computer will emit a
10-second signal.
PULSE
• Press
• To measure your heart rate, place both hands firmly on the hand
sensor contact pads.
• After 6–7 seconds, your heart rate (in beats per minute, BPM) will
appear on the display.
NOTE!
Initial readings may be temporarily elevated due to signal
interference. After 2–3 seconds, the measurement should stabilize.
This reading is intended for fitness reference only and is not suitable
for medical use.
ALARM SOUND
• The computer emits a sound when any of the
buttons are pressed.
AUTO ON/OFF & AUTO START/STOP
• If no activity is detected for 4 minutes, the display will shut off
automatically to save power.
• The display will automatically turn on when the pedals start
moving or when any button is pressed.
Console specifications
Function
to input a target
Battery type
Operating temperature
Storage temperature
Technical data
Parameter
to input a target
Length
Width
Height
Weight
Max. user weight
until "CAL" appears, then press
until "PULSE" appears.
Auto scan Every 5 seconds
Time 00:00 - 99:59
Speed 0.0 - 999.9 km/h
Distance 0.00 - 999.9 km
Calories 0.0 - 9999 Kcal
Pulse rate 40 - 240 BPM
2 x AAA
°C
0 - 40
°C
-10
Value
140 cm
60 cm
83 cm
25 kg
120 kg
to input a target
, , or
°C
°C
- 60
10