General Safety Instructions; Layout And Items Supplied; Proper Use; Environmental Protection - EINHELL ROYAL BSF 55 Bedienungsanleitung

Anleitung BSF 55_SPK7:_
Packaging
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage.
Read the operating instructions carefully and
comply with them. It is important to consult these
instructions in order to acquaint yourself with the
unit, its proper use and safety regulations.
Keep this manual in a safe place, so that the
information is available at all times.
If you give the equipment to any other person,
give them these operating instructions as well.
We cannot accept any liability for damage or
accidents which arise due to a failure to follow
these instructions.

1. General safety instructions

The general safety instructions and explanations of
the information signs on the unit are set out in the
enclosed booklet.

2. Layout and items supplied

1. Push bar
2. Control lever for drive unit
3. Control lever for plow unit
4. Adjustment crank for snow ejection unit
5. Selector lever
6. Tank
7. Air filter
8. Snow ejection unit
9. Plow unit
10. Skids
11. Wheels
12. ON/OFF switch
13. Throttle lever
14. Choke lever
15. Petrol cock
16. Starter cable-reversing starter
17. 1x bolt M6x25
18. 1x nut M6
19. 1x split pin
15
14.01.2008 8:59 Uhr Seite 15
20. 2x washers for push bar assembly (8 mm
diameter)
21. 2x bolts for push bar assembly M8x20
22. 2x holding plates for push bar
23. 2x bolts for push bar assembly M8x40
24. 3x plastic holders for fitting the ejection unit
25. 6x nuts M6
26. 6x bolts M6x20
27. 6x washers, diameter 6 mm
28. 1x washer for adjusting the ejection, diameter
10 mm
29. 2x spare safety nuts M8
30. 2x spare shearing bolts M8x40
31. 1x spark plug wrench
32. 1x bolt for spark plug wrench
33. Oil filler funnel with hose

3. Proper use

The unit is designed for clearing snow from
compacted surfaces such as paths, drives and yards.
Be sure to observe the restrictions in the safety
instructions.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Environmental protection

Dispose of soiled maintenance material and
operating materials at the appropriate collection
point.
Recycle packaging material, metal and plastics.
5. Assembly (see Fig. 4-20)
Assemble the push bar (1) as shown in Fig. 4
and 5.
Fit the clutch cables as shown in Fig. 6-9. First
unscrew the cable tensioner and place the cable
for the plow unit through the hole in the push bar
provided for it as shown in Fig. 7. Attach the
tensioning hook on the clutch cables to the holes
provided for it on the control levers as shown in
Fig. 8. After you have attached the clutch cables,
the cables must be tensioned using the cable
tensioner (Fig. 9) so that the drive unit and the
GB