Safety Regulations; General Safety Instructions; Equipment Layout And Items Supplied; Intended Use - EINHELL Royal ESF 1839 Bedienungsanleitung

Anleitung_ESF_1839_SPK7:_
Packaging
The unit is supplied in packaging to prevent it from
being damaged in transit. The raw materials in this
packaging can be reused or recycled.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage.
Read the operating instructions carefully and
comply with them at all times. It is important to
consult these instructions in order to acquaint
yourself with the unit, its proper use and the
important safety regulations.
Keep this manual in a safe place, so that the
information is available at all times.
If you give the equipment to any other person,
make sure that you pass on these operating
instructions as well.
We can accept no liability for damage or
accidents which arise due to non-compliance
with these instructions.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
2. Equipment layout and items
supplied (Fig. 1-2)
1. Top push bar
2. Bottom push bar
3. Ejection range adjustment
4. Ejecting direction adjustment
5. Ejector
6. Plow unit
7. Wheels
8. Mains plug
9. Two-point safety switch
10. 4 x screws for push bar assembly
11. 4 x washers for push bar assembly
12. 4 x star nuts for push bar assembly
13. Cable strain-relief clamp
14. 3 x cable clips
15. 2 x screws for ejector assembly
30.05.2007 17:30 Uhr Seite 11

3. Intended use

The equipment is designed for clearing snow from
paved paths and drives.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Power supply
The equipment can be connected to any light socket-
outlet (with 230 Volt alternating current). However,
the socket outlet must have an earthing contact
protected by a 16 A circuit breaker. Additionally, a
residual current device (RCD) circuit-breaker with
max. 30 mA must be used!
Mains lead
Only use a mains lead that is in perfect condition.
The mains lead must not exceed a certain length
(max. 50m), since otherwise the power of the electric
motor will fall. The mains lead must have a cross-
section of 3 x 1.5mm
are particularly susceptible to insulation damage.
The causes of this include the following:
- Cutting the cable by passing over it with the
mower
- Damage through crushing if the mains lead is
routed under doors or windows
- Cracks caused by ageing of the insulation sheath
- Kinks caused by incorrect fastening or routing of
the mains lead.
Such damaged mains leads should not be used
under any circumstances as they may cause fatal
injuries due to their damaged insulation sheath.
Cables, plugs and connection sockets must satisfy
the conditions listed below. Mains leads for
connecting snow throwers must have rubber
insulation sheaths.
The mains leads must be at least type H05RN-F and
have three wires. The type designation must be
printed on the mains lead. Only buy mains leads that
have their type data printed on them. The plugs and
connection sockets on mains leads must be made of
rubber and be splashproof. Mains leads are subject
to length restrictions. Long mains leads require larger
cable cross-sections. Mains leads and connection
cables must be checked at regular intervals for signs
of damage. Ensure that the leads are not connected
to the power supply when you check them. Uncoil
the mains lead in full. Also check the mains lead
connection points at plugs and connection sockets
for kinks.
GB
2 . Mains leads on lawn mowers
11