Storage; Waste Disposal; Ordering Spare Parts - EINHELL ROYAL BSF 55 Bedienungsanleitung

Anleitung BSF 55_SPK7:_
GB
simply insert it up to the thread.
Dispose of the waste oil properly.
Automatic oil cut-out
The automatic oil cut-out responds if there is too little
oil in the engine. In this case it will not be possible to
start the engine, or it will cut out automatically after a
short period of time. It cannot be started again until
the engine oil has been topped up (see point 9.3).
9.4 Adjusting the cables (Fig. 9)
In the driving and plowing setting it should be
possible to push the clutch cables up to the push bar
without this requiring much effort. If the cables are
too taut for this, they must be extended. To do this,
undo the knurled nut (Fig. 9 / Item A) opposite the
main cable, extend the screw connector and then
tighten the knurled nut again. If the power of the
drive unit falls or the plow unit no longer rotates, the
cable length must be reduced using the screw
connection (using the same procedure described
above).

10. Storage

Fill the fuel tank before you decommission the unit
for a lengthy period of time.
Clean the snow plow and coat all the metal parts with
a thin film of oil to prevent them rusting.
Store the snow plow in a clean, dry room.

11. Waste disposal

Important.
The snow plow and its accessories are made of
various types of material, such as metal, fluids and
plastic.
Take any defective components and fluids that are
no longer in use to special waste disposal points.
Ask your dealer or your local council.

12. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of unit
Article number of the unit
ID number of the unit
Number of the required spare part
18
14.01.2008 8:59 Uhr Seite 18
For our latest prices and information please go to
www.isc-gmbh.info