Cleaning Jar, Lids And Blade Assembly Separately - Gastroback Design Micro Blender Bedienungsanleitung

Always handle the blade assembly with caution to avoid injuries,
WARNING:
as the blades are very sharp.
not fill the jar over the MAX filling line to avoid overheating. Do not fill in hot
The dishwater for cleaning may be hand-warm at the maximum.
liquids.
1. Rinse the jar and blade assembly with clear tap water.
Tip:
Possibly, fibrous foods leave stubborn residues on the blades. Before running the
following cleaning process, remove these residues via a small soft brush (e.g. a
toothbrush) and rinse with clear tap water.
2. Fill the jar up to the MAX FILL line with lukewarm dishwater. However do not
overfill the jar. Then replace the blade assembly.
3. Operate the appliance with some pulses. See: ›Processing Your Food‹.
4. If some leftover particles dried onto the interior of the jar, fill the jar again with
about 100 ml lukewarm dishwater and screw on the blade assembly. Leave the
jar soak for approx. 10 minutes. Then lock the jar onto the motor base and let
the appliance operate for about 20-30 seconds to loosen the residues.
5. When the jar is clean, remove the jar from the motor base and unplug the motor
base. Remove the blade assembly from the jar and discard the water. Rinse jar
and blade assembly under running tap water.
6. Dry all parts thoroughly and leave dry naturally where the parts are out of
reach of young children.
Tip:
If this method is not sufficient, you should clean the parts according to the instruc-
tions below.

CLEANING JAR, LIDS AND BLADE ASSEMBLY SEPARATELY

If you wish a somewhat more thorough cleaning of the jar, lids and blade assembly,
or if food dried on these parts of the appliance and could not be removed via the
method described above, you may clean jar, lid and blade assembly according to
the following instructions.
WARNING – Risk of Injuries!
care and avoid touching the blades with your fingers. Only hold the blade assembly
by its base. Do not attempt to disassemble the blade assembly. Always ensure that
the appliance and all its parts are out of reach of young children.
1. Remove the jar from the motor base. Unplug the appliance.
Only touch the blade assembly by its base. Do
The blades are very sharp. Handle with special
43