Herunterladen Inhalt Inhalt Diese Seite drucken

Power Supply - Conrad CV Mobil 4200 FM Bedienungsanleitung

Cb-funkgerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Also mount the microphone hanger using the enclosed screws in an easily-
accessible place.
In order to prevent interference to the vehicle electronics from transmission in the
vehicle, please make sure to take any mounting instructions from the vehicle
manufacturer for radios and antennas into account.
Please note: European directives allow the car manufacturers to decide, whether or
not private radio transceivers may be operated in cars, this is also valid for antenna
installations. Please install Your mobile CB station only in accordance to car
manufacturer's installation instructions.
Your CV mobil 4200 FM will get DC power from the 2 pin fixed power cable.
The red and black wires in the cable are for the 12 V power supply. The cable has a
looped-in fuse.
You can choose from two methods when connecting to the power supply (red and
black):
Example 1
The radio should be able to be switched on and off at any time using the
volume / on/off switch.
Connect up the red to the positive pole on the vehicle battery (or elsewhere
in the vehicle's electrical system with permanent plus) or to a 12 volt power
unit.
Connect up the black wire to the negative pole on the vehicle battery or the
power unit or to a well-conductive part of the car body.
Example 2
The set should be automatically switched on and off with the ignition switch
of the car. The radio shall always start in last used mode on the last used
channel.
Attach the red wire to a part of the vehicle electrical system which is
interconnected to the ignition.
Connect the black wire to the negative pole on the battery or the vehicle
body.
Note for all connecting methods:
For EMC reasons, the cable used to connect to the power supply should be no longer
than 3 metres.
If you wish to operate your set at home from the mains supply then please only use
a stabilised power pack with at least 2 amps permanent current-carrying capacity.
Under no circumstances should you use a car battery charger, as these are not

Power supply

5

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis