Maintenance; A) Cleaning; Fuse Replacement - Conrad 1302513 Bedienungsanleitung

14. Maintenance

Regularly check the technical safety of the LED light system, e.g. for damage to the mains cable or the casing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and make
sure it is not operated unintentionally. Pull the mains plug from the mains socket!
It can be assumed that safe operation is no longer possible if:
• the device shows visible damage
• the device is no longer working
• the device has been stored under unfavourable conditions for an extended period of time or
• the device has been subjected to heavy stress during transport.
Always observe the following safety information before cleaning or servicing the LED light system:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work is
carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must per-
form repairs.

a) Cleaning

Clean the exterior of the LED light system with a soft, dry cloth or brush only.
Never use any aggressive cleaning agents or chemical solutions as these may damage the surface of the casing.
b) Fuse replacement
If you have to replace the fuse, ensure that you only use fuses of the specified type and rated current (see "Technical
data") as a replacement.
Never repair fuses or bridge the fuse holder.
• Unplug the mains plug from the mains socket and disconnect the low-voltage cable from the POWER INPUT mains
socket (1) on the device.
• Using a suitable screwdriver, carefully lever out the fuse holder of the mains connection (1) with the defective fuse.
• Remove the defective fuse and replace it by a new fuse of the indicated type.
• Carefully push the fuse holder with the new fuse back into its position at the mains connection of the device.
• After this, you can reconnect the device to the mains and take it into operation.
34