Blender Mode; Sterilization Mode - Create Baby Chefbot Bedienungsanleitung

B LE N DE R MOD E
1. Place cooked or fresh food directly into the jar.
2. Install the splash guard and close it. The protruding element of the splash guard must be
inserted into the round hole on the side of the jug.
3. Place the lid on the jug and then place the jug into the main body of the product.
4. Switch on the appliance and press the beat button to select the beater mode.
5. Press the +/- buttons to select the number of cycles from 1 to 5.
6. To start the mixer mode press the start button. If you want to pause the process, you must
press this button again.
• The volume of all ingredients in the blender container should not exceed 300 ml.
• ATTENTION: Before starting the blender mode, make sure the jug is installed correctly.
• The inlet on the side of the jug must exactly match the steam outlet on the appliance.
• It is not recommended to use the blender function without food in the jug.
ST E R ILI Z ATI ON MOD E
1. Fill the container with water, without exceeding the "MAX" mark located on the left side
of the appliance.
2. Insert the steamer basket into the jug, then place the utensils you want to sterilize inside
the steamer basket.
3. Install the jug into the main body and turn it counterclockwise until it stops. Then place the
measuring cup to cover the jug.
4. Switch on the appliance and activate the sterilisation mode by pressing the sterilise but-
ton. You can press the +/- buttons to increase or decrease the sterilisation time from 1 to
30 minutes.
5. Then press the start button to turn on the appliance. If you want to pause the mode during
operation, press the button again.
6. Once sterilization is complete, the device will beep 3 times.
7. Remove the measuring cup and remove the utensils from inside using the tongs.
E NGL I SH
12