General Safety Instructions; General Power Tool Safety Warnings - Parkside Pusa 20-Li B1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

NOTE
The speci ed total vibration values
u
and the noise emission values can
also be used to make a provisional
load estimate.
WARNING!
m
Depending on the manner in which
u
the power tool is being used, and
in particular the kind of workpiece
being worked, the vibration and
noise emission values can deviate
from the values given in these
instructions during actual use of
the power tool.
Try to keep the vibration loads
u
as low as possible. Measures to
reduce the vibration load are, e.g.
wearing gloves and limiting the
working time. Wherein all states
of operation must be included
(e.g. times when the power tool
is switched o and times where
the power tool is switched on but
running without load).
General safety
instructions
˜ General power tool safety
warnings
WARNING!
m
Read all safety warnings,
u
instructions, illustrations and
power tool. Failure to follow the
warnings and instructions may
result in electric shock
serious injury.
26 GB/IE
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings
refers to your mains-operated (corded)
power tool or battery-operated (cordless)
power tool.
1)
lit. Cluttered or dark areas invite
accidents.
2) Do not operate power tools in
explosive atmospheres, such as in
gases or dust. Power tools create
sparks which may ignite the dust or
fumes.
3) Keep children and bystanders
away while operating a power
tool. Distractions can cause you to
lose control.
Electrical safety
1) The mains plug of the power tool
modify the plug in any way. Do not
use any adapter plugs with earthed
(grounded) power tools. Unmodi ed
plugs and matching outlets will
reduce risk of electric shock.
2) Avoid body contact with earthed
or grounded surfaces, such as
pipes, radiators, ranges and
refrigerators. There is an increased
risk of electric shock if your body is
earthed or grounded.
3) Do not expose power tools to rain
or wet conditions. Water entering
a power tool will increase the risk of
electric shock.
4) Do not abuse the cord. Never use
re and or
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged
or entangled cords increase the risk
of electric shock.
N