Controls & Display - Levoit Core 600S Smart Bedienungsanleitung

C O N T R O L S & D I S P L AY
Note: You can also use the VeSync app to control these functions, as well as additional app-only features
(see page 14).
On/Off Button
•
Turns the air purifier on/off.
•
Press and hold for 5
seconds to configure the
air purifier. See the VeSync
in-app instructions for more
information.
•
Press and hold for 15 seconds
to reset the air purifier and
disconnect from Wi-Fi (see
page 9).
Air Quality Indicator Rings
•
These indicators use an
automatic sensor to display
the air quality: Blue (Very
Good), Green (Good), Orange
(Moderate), and Red (Bad).
Wi-Fi Indicator
•
Turns on, off, or blinks to
indicate pairing status. See the
VeSync in-app instructions for
more information.
Light Sensor
The Light Sensor detects the
amount of light in the room to
automatically adjust the air purifier
settings (see Light Detection, page
14).
•
Light Detection can be turned
on/off in the VeSync App.
• Press and hold display
button for 3 seconds
also turns on/off the light
detection function.
Fan Speed Button
•
Cycles through fan speeds:
low (1 indicator will light up),
medium (2 indicators), high (3
indicators), and turbo
(4 indicators).
•
Tapping the Fan Speed Button
while the air purifier is in Auto
Mode or Sleep Mode (if the
display is on) will exit that
mode.
Sleep Mode Button
•
Turns Sleep Mode on/off (see
page 10).
Timer Button
•
Cycles through timer options
(see page 12).
•
Press and hold
seconds to begin cycling
through the timer options in
1-hour increments.
Auto Mode Button
•
Turns Auto Mode on/off (see
page 11).
Display Off Button
•
Turns the display off
(see page 12).
•
Tap any button (except
turn the display back on.
Display Lock Button
•
Prevents current settings from
being changed (see page 12).
Press and hold for 3 seconds
to turn Display Lock on/off.
•
The Display Lock Indicator (
) will blink when any other
button is tapped to indicate
that Display Lock is on.
Check Filter Indicator Reset
Button
•
Press and hold for 3 seconds
to reset the Check Filter
Indicator.
•
The Check Filter Indicator
( ) lights up when the filter
should be checked (see page
16).
EN
for 2
) to
7