Display Led - Homcom 824-004 Bedienungsanleitung

EN
2. POWER: Turn the FAN on by pressing the 'POWER' button; Turn the FAN off by
pressing the 'POWER' button again.
3. SPEED: You can adjust the fan speed to the desired level: low, medium, or high by
pressing 'SPEED'. The speed setting is displayed on the LED screen (shown in Figure 4).
4. MODE: Pressing the 'MODE' button will set the FAN into NORMAL, NATURAL, and
SLEEP mode.
5. TIMER: The fan is equipped with a timer that allows you to set it's length of operation
from 1 hour to 12 hours.
6. OSC: Pressing the 'OSC' button will start and stop the oscillation function. The symbol
is displayed on the LED screen.
7. TEMP: Once the unit plug into the power socket or switch on, the FAN will show the
room temperature, and the 'TEMP' will change to 'TIMER' when the timer is set.
8. Power save mode: when the 'sleep' mode or the 'timer is on, the main display will be
off after 30 seconds, and you can press any keys to turnon the display again.
9. DISPLAY LED- can be switched off temporarily by pressing the LED button on the
remote control or by pressing and holding the SPEED button on the control panel from
more than 3 seconds, the display will light up again once any control button is activated.
MAINTENANCE
1. This can only be done by an authorized service agent such as your local sealer dealer
or any agent qualified to undertake electrical repairs.
2. lf the unit requires external cleaning make sure it is switched off and unplugged from the
mains supply. Use a soft tissue or cloth for general clean-ing. To remove more persistent
dirt or grime wipe down with a cloth that has been dampened with warm soapy water. Do
not use any solvents (such as thinners) as these may damage the plastic casing.
NOTICE
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• lf the supply cord is damaged, it must be replaced by the manufacture, its service agent
or similarly qualified persons in order to avoid a hazard.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
4