WimTec OCEAN P7 Montage- Und Bedienungsanleitung Seite 28

EN
OCEAN P7
Program description
Warm water rinse:
DIP-switch 4
Serves to rinse the warm water pipe without the need for you to
remain within the sensor range of the shower.
Dip-switch 4 ON = Warm water rinse enabled (default setting).
Dip-switch 4 OFF = Warm water rinse disabled.
User detection
To activate the shower, the
user must enter the active
range.
30-70 cm
28 Shower panel
Switch on warm water rinse
5 s after user detection the
user has time by tapping on
the ON/OFF icon to start the
warm water rinse without
beeing in the active range.
Thereby the vertical line of the
ON/OFF symbol is glowing.
WimTec OCEAN P7
It is recommended, to
combine the Warm water rinse
function not with the fully
automatic program!
Operation
After activation, water will
flow for 30 s plus the configu-
ON
OFF
1 2 3 4 5 6
red shut-off delay without the
need for you to remain within
the sensor range; it will then
automatically shut down again.
If you enter the sensor range
for at least 5 s during these
30 s, the shower will resume
normal operation.
Warmlauf:
OFF
ON
6 5 4 3 2 1
Reinigungsstopp:
OFF
!
ON
6 5 4 3 2 1
Hygienespülung:
OFF
ON
6 5 4 3 2 1
Halbautomatik:
OFF
ON
6 5 4 3 2 1
Vollautomatik:
OFF
ON
6 5 4 3 2 1
Manuell:
OFF
ON
6 5 4 3 2 1