OCEAN P7
Assembly
1
4
!
ATTENTION!
Perform the following steps
in the order indicated!
2
5
1.
Screw on protection cover at the top of the shower panel.
2.
Move down the base plate, lift carefully and unhook.
3.
Stick boring template at the back wall. Consider lower edge
of shower head for mounting in desired height
(standard: 200 - 210 cm).
4. Prepare four mounting holes ø 8 mm and remove the
template then.
5.
Mount wall fixing angles and shutt-off valves vertical,
standing upwards.
6.
Carry out pre-flushing.
3
6
WimTec OCEAN P7
Shower panel
EN
21