Interrupting Operation; Finish Operation - Kärcher K 4.98 M Bedienungsanleitung

Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure
that you have a firm footing and are also hold-
ing the trigger gun and spray lance firmly.
Illustration
Unlock the lever on the trigger gun.
Illustration
Pull on the lever of the trigger gun; the de-
vice will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.
Spray lance with pressure regulation
Carrying out the most common cleaning
tasks. The work pressure can be stagelessly
regulated between "Min" and "Max".
Release the lever on the trigger gun.
Turn the spray lance to the desired posi-
tion.
Spray lance with dirt blaster
For particularly dirty items or areas.
Not suitable for use with detergents.
Operation with detergent
Please use exclusively KÄRCHER detergents
and care products to carry out the respective
cleaning task, as these were specifically de-
velopped for your appliance. The use of other
detergents and care products may lead to pre-
mature wear and can invalidate your warranty
claims. Please obtain information at your local
dealer or request information directly from
KÄRCHER.
Illustration
Fill the detergent solution in the detergent
tank (observe dosage instructions on the
packaging of the detergent).
Use spray lance with pressure regulation
(Vario Power).
Illustration
Turn the spray lance to "Mix" position - low
pressure.
12
English
Recommended cleaning method
Spray the detergent sparingly on the dry
surface and allow it to react, but not to dry.
Spray off loosened dirt with the high-pres-
sure jet.

Interrupting operation

Release the lever on the trigger gun.
Lock the lever on the trigger gun.
During longer breaks (more than 5 min-
utes), also turn the appliance off using the
"0/OFF" switch.
Insert the trigger gun in its holder.

Finish operation

Caution
Only separate the high-pressure hose from
the trigger gun or the appliance while there is
no pressure in the system.
After working with detergent, suspend de-
tergent suction hose in a container filled
with clear water, switch the appliance on
for around 1 minute once the spray lance
has been removed and rinse until water
runs clear.
Release the lever on the trigger gun.
Turn off the appliance "0/OFF".
Turn off tap.
Detach the appliance from the water sup-
ply.
Press the lever on the trigger gun to re-
lease any remaining pressure in the sys-
tem.
Lock the lever on the trigger gun.
Pull out the mains plug.
Roll up the power cord and loop it e.g.
round the handle.
Insert the trigger gun in its holder.
Stow away the accessories in the acces-
sory holder.